RIGHT side wheel-motor-to-mainboard wiring harness for Shark Ion and IQ robot vacuums. Fixes wheel errors, intermittent wheel drop-out, or a wheel that stopped responding after the harness was pinched or chewed. This is the right-side harness only - the left side is a separate part (linked below).
Check before ordering: Right side only. Compare the plug and wire routing in the photos to your old harness to be sure you are ordering the correct side.
Power off and remove the battery → remove the bottom cover → unplug the old harness at the mainboard and wheel motor → route the new harness along the same path → plug in both ends → reassemble. ~10 min.
BotPartsDirect is an independent parts retailer. Shark® and all model names are trademarks of SharkNinja Operating LLC. We are not affiliated with or endorsed by SharkNinja.
Customers who bought this part also purchased:
Browse all replacement parts →
Ordered this for my RV750 after the original motor burned out. Dropped right in — same connector, same wire colors. Vacuum runs like new. Shipping was fast too.
My Shark Ion was making a grinding noise and losing suction. Replaced this part and it's back to 100%. Way cheaper than a new unit. Very happy with the quality.
Part arrived in 3 days. Installation took about 15 minutes following the guide on the site. Everything snapped in perfectly. Would order from here again.
Part itself is solid and fits correctly. Took me a bit longer to figure out the wiring harness clip but got it eventually. Works great now.
✓ Thanks for your review! It will appear after moderation.