Left wheel wiring harness for Shark Ion and IQ series robot vacuums. Fixes intermittent or dead left-wheel operation caused by a broken or chafed harness — no need to replace the whole wheel module.
Power off → remove bottom cover → unplug the old harness at both ends → route the new harness the same way → reassemble. ~15 min.
BotPartsDirect is an independent parts retailer. Shark® and all model names are trademarks of SharkNinja Operating LLC. We are not affiliated with or endorsed by SharkNinja.
Ordered this for my RV750 after the original motor burned out. Dropped right in — same connector, same wire colors. Vacuum runs like new. Shipping was fast too.
My Shark Ion was making a grinding noise and losing suction. Replaced this part and it's back to 100%. Way cheaper than a new unit. Very happy with the quality.
Part arrived in 3 days. Installation took about 15 minutes following the guide on the site. Everything snapped in perfectly. Would order from here again.
Part itself is solid and fits correctly. Took me a bit longer to figure out the wiring harness clip but got it eventually. Works great now.
✓ Thanks for your review! It will appear after moderation.