RIGHT wheel motor housing cover bracket for Shark Ion robot vacuums. This is the plastic cover/bracket that holds the drive wheel module in the chassis - it is NOT the wheel or motor. Replace it if the old one cracked or the mounting tabs broke.
Check before ordering: There are several similar-looking housings. Compare the red-circled areas in the photos to your old cover before ordering. Right side only.
Power off → remove the bottom cover → unscrew the wheel module → swap the cover bracket onto the module → reinstall. ~10 min.
BotPartsDirect is an independent parts retailer. Shark® and all model names are trademarks of SharkNinja Operating LLC. We are not affiliated with or endorsed by SharkNinja.
Customers who bought this part also purchased:
Browse all replacement parts →
Ordered this for my RV750 after the original motor burned out. Dropped right in — same connector, same wire colors. Vacuum runs like new. Shipping was fast too.
My Shark Ion was making a grinding noise and losing suction. Replaced this part and it's back to 100%. Way cheaper than a new unit. Very happy with the quality.
Part arrived in 3 days. Installation took about 15 minutes following the guide on the site. Everything snapped in perfectly. Would order from here again.
Part itself is solid and fits correctly. Took me a bit longer to figure out the wiring harness clip but got it eventually. Works great now.
✓ Thanks for your review! It will appear after moderation.