LEFT side brush motor module for Shark IQ robot vacuums - gear housing stamped "A2 L". Complete genuine OEM module (motor, gearbox and housing) with the factory 2-wire plug and harness attached, so it plugs straight into the mainboard with no cutting or soldering. Drives the small side brush only, not the main brushroll.
Check before ordering: Flip your old motor over - the gear housing should read A2 L. If it reads A1 L, A1 R, or 360 L this is not your part.
Power off → remove the side brush → remove the bottom cover → unplug the old module at the mainboard and lift it out → seat the new module, plug in → reassemble and refit the brush. ~10 min.
BotPartsDirect is an independent parts retailer. Shark® and all model names are trademarks of SharkNinja Operating LLC. We are not affiliated with or endorsed by SharkNinja.
Customers who bought this part also purchased:
Browse all replacement parts →
Ordered this for my RV750 after the original motor burned out. Dropped right in — same connector, same wire colors. Vacuum runs like new. Shipping was fast too.
My Shark Ion was making a grinding noise and losing suction. Replaced this part and it's back to 100%. Way cheaper than a new unit. Very happy with the quality.
Part arrived in 3 days. Installation took about 15 minutes following the guide on the site. Everything snapped in perfectly. Would order from here again.
Part itself is solid and fits correctly. Took me a bit longer to figure out the wiring harness clip but got it eventually. Works great now.
✓ Thanks for your review! It will appear after moderation.