RIGHT side spin-brush motor module for Shark Ion "N" generation robot vacuums. Drives the small edge-sweeping side brush only (not the main brushroll). Restores edge cleaning when the right side brush has stopped spinning or spins weakly.
Check before ordering: These are the "N" generation models - the model number on the sticker under your robot must end in N (e.g. RV750N), or be one of the RV850 / RV860 series listed. Non-N RV700 / RV720 / RV725 / RV750 / RV755 robots use a different part.
Power off → remove the side brush screw and brush → remove the bottom cover → unplug and unclip the old motor → seat the new motor and plug in → reassemble and refit the brush. ~5 min.
BotPartsDirect is an independent parts retailer. Shark® and all model names are trademarks of SharkNinja Operating LLC. We are not affiliated with or endorsed by SharkNinja.
Customers who bought this part also purchased:
Browse all replacement parts →
Ordered this for my RV750 after the original motor burned out. Dropped right in — same connector, same wire colors. Vacuum runs like new. Shipping was fast too.
My Shark Ion was making a grinding noise and losing suction. Replaced this part and it's back to 100%. Way cheaper than a new unit. Very happy with the quality.
Part arrived in 3 days. Installation took about 15 minutes following the guide on the site. Everything snapped in perfectly. Would order from here again.
Part itself is solid and fits correctly. Took me a bit longer to figure out the wiring harness clip but got it eventually. Works great now.
✓ Thanks for your review! It will appear after moderation.