Cliff (drop) infrared sensor set for Shark Ion R01US-series robot vacuums. Includes three infrared drop sensors for the front and sides. Prevents the robot from driving off stairs and ledges and clears cliff-sensor errors.
Check before ordering: Check the full model number on the sticker under your robot - it should end in R00US or R01US.
Power off and remove the battery → remove the bottom cover → unplug the sensor harnesses → swap the sensors → reassemble. ~15 min.
BotPartsDirect is an independent parts retailer. Shark® and all model names are trademarks of SharkNinja Operating LLC. We are not affiliated with or endorsed by SharkNinja.
Customers who bought this part also purchased:
Browse all replacement parts →
Ordered this for my RV750 after the original motor burned out. Dropped right in — same connector, same wire colors. Vacuum runs like new. Shipping was fast too.
My Shark Ion was making a grinding noise and losing suction. Replaced this part and it's back to 100%. Way cheaper than a new unit. Very happy with the quality.
Part arrived in 3 days. Installation took about 15 minutes following the guide on the site. Everything snapped in perfectly. Would order from here again.
Part itself is solid and fits correctly. Took me a bit longer to figure out the wiring harness clip but got it eventually. Works great now.
✓ Thanks for your review! It will appear after moderation.