Cliff (drop) infrared sensor set for the original Shark AI / AI VacMop RV2000-series robots. Includes three infrared distance sensors plus the wiring harness and connectors. Fixes "cliff sensor" errors, a robot that refuses to leave the dock, or one that drives off steps.
Power off and remove the battery → remove the bottom cover → unplug the sensor harness at the mainboard → unclip the old sensors → seat the new sensors and route the harness → reassemble. ~15 min.
BotPartsDirect is an independent parts retailer. Shark® and all model names are trademarks of SharkNinja Operating LLC. We are not affiliated with or endorsed by SharkNinja.
Customers who bought this part also purchased:
Browse all replacement parts →
Ordered this for my RV750 after the original motor burned out. Dropped right in — same connector, same wire colors. Vacuum runs like new. Shipping was fast too.
My Shark Ion was making a grinding noise and losing suction. Replaced this part and it's back to 100%. Way cheaper than a new unit. Very happy with the quality.
Part arrived in 3 days. Installation took about 15 minutes following the guide on the site. Everything snapped in perfectly. Would order from here again.
Part itself is solid and fits correctly. Took me a bit longer to figure out the wiring harness clip but got it eventually. Works great now.
✓ Thanks for your review! It will appear after moderation.