LEFT wheel and motor assembly for the original Shark Ion RV700-series robots (RV700, RV720, RV725, RV750, RV755). Fixes a wheel that will not spin or a robot that pulls to one side.
Check before ordering: Fits the original (non-N) RV700-series robots only. Will NOT fit if the model number on the sticker under your robot ends in the letter N (RV750N, RV725N, etc.) or is an RV850 / RV860 / RV761 / RV754 model.
Power off and remove the battery → remove the bottom cover → unscrew the wheel module and unplug its harness → install the new module → reassemble. ~15 min.
BotPartsDirect is an independent parts retailer. Shark® and all model names are trademarks of SharkNinja Operating LLC. We are not affiliated with or endorsed by SharkNinja.
Customers who bought this part also purchased:
Browse all replacement parts →
Ordered this for my RV750 after the original motor burned out. Dropped right in — same connector, same wire colors. Vacuum runs like new. Shipping was fast too.
My Shark Ion was making a grinding noise and losing suction. Replaced this part and it's back to 100%. Way cheaper than a new unit. Very happy with the quality.
Part arrived in 3 days. Installation took about 15 minutes following the guide on the site. Everything snapped in perfectly. Would order from here again.
Part itself is solid and fits correctly. Took me a bit longer to figure out the wiring harness clip but got it eventually. Works great now.
✓ Thanks for your review! It will appear after moderation.